Stabilizing Bar Assembly Instructions
Products
Rebounders
DVDs
Books
Shopping Cart
Home
Support
About Us
Contact Us
Affiliates
Resellers
Needak Rebounders, Exercise Equipment, Oneill, NE
facebook



(This page contains a large number of photographs and may take between 1 1/2 and 2 minutes to load at 56K.)

  Use any combination of 2 legs-skip one leg between the pair. The hands shown on the picture illustrate which legs to choose.

Remove rubber leg tips from two legs of the rebounder. Tips may be removed by cradling the leg in your fingers and pushing them off with your thumbs or with a screwdriver as shown. (Do not slip with the screwdriver or you may injure yourself or damage the jump mat).

Tip: Apply Vaseline to the inside of the leg tips for easier replacement.

Slide the vertical bars over rebounder legs and replace the leg tips.

Position bar legs so the spring buttons are perpendicular with the rebounder frame.

Note: During shipment, the spring buttons may slide away from the hole. Use a needle nose pliers to retrieve the button and reposition.

Connect the two halves of the stabilizing bar by depressing the spring button. Push the two pieces together while twisting slightly until the button and hole match.
You next need to determine the "front" of the stabilizing bar. When standing on the floor in front of the rebounder, the spring button will be on the left. (When standing on the rebounder it will logically be on your right.)
Position the top portion of the bar over the vertical legs and slide them down evenly to the desired height and lock in place with the spring buttons.
The stabilizing bar is designed to flex slightly with your movement as you rebound. Some movement in the assembled bar is normal and necessary to prevent injury.

View Product Line



Bargain Den  |   Shopping Cart  |   Warranty  |   Health Benefits  |   Testimonials  |   Endorsements  |   Contact Us  |   Privacy Policy  |   Products  |   Lead & Vinyl  |   FAQ's  |   Are We Green?  |   CPSC / CPSIA  |   Search  |   Site Map  |  

Needak Manufacturing, LLC, 124 S 8th Street, O'Neill, NE  68763     1-800-232-5762 or 1-402-336-4083        Information
Copyright Needak Manufacturing LLC 1999-2017.  No portion of this site may be used without permission.

All rights reserved.


Powered By AthenaGold