Mat Replacement Instructions
Products
Rebounders
DVDs
Books
Shopping Cart
Home
Support
About Us
Contact Us
Affiliates
Resellers
Needak Rebounders, Exercise Equipment, Oneill, NE
facebook

If you wish to save the jump mat, please review the Spring Removal Instructions to disconnect all 36 springs.

Position the rebounder on the floor or a table with legs extended.  To gain access to the springs and edges of the mat, you may remove the spring cover from the rebounder.  This is done by pulling the “bungee” cord over each leg.  You may also slip it over the edge and press it down toward the leg tips.
     
With the mat fully exposed, you will remove the old mat with a scissors or utility knife.  The polypropylene material used for the jump surface and the edge webbing are very tough.  Be cautious of your cutting tool and remain in control during the cut.  Begin by cutting from the center of the mat toward and through the outer webbing.  Repeat this as many times as necessary to remove the mat.
With the mat now removed, inspect the clevis pins that pass through the frame for excessive wear on the eye of the pin.
   Non-Folding rebounders

Place the mat in the center of the frame.  Begin attaching springs to the mat.  Please make sure 2 springs attach to each mat cleat. (Spring replacement instructions appear on the back of this page)

   Folding rebounders

In order for the rebounder to properly close, the grain of the mat must be in line with the hinges.  At left is an example of the weave of permatron.  The fibers are crossed to form 2 perpendicular axes.  The grain is either set of fibers.

 



 

 

 

 

Folded Correctly

The grain of the mat passes between 2 cleats which will attach between the 2 hinges of the rebounder.  The negative grain will pass directly into 2 mat cleats.

 

 

 

 

 

Folded Improperly

Begin by attaching 2 springs to the mat on either side of one hinge.  Move to the other hinge and do the same.  You can then attach the remaining springs.  Spring Replacement Instructions
Finally, lubricate the contact points between the springs and mat cleats and if necessary the point where the springs enter the Clevis Pins and replace the spring cover.

 

View Product Line

 



Bargain Den  |   Shopping Cart  |   Warranty  |   Health Benefits  |   Testimonials  |   Endorsements  |   Contact Us  |   Privacy Policy  |   Products  |   Lead & Vinyl  |   FAQ's  |   Are We Green?  |   CPSC / CPSIA  |   Search  |   Site Map  |  

Needak Manufacturing, LLC, 124 S 8th Street, O'Neill, NE  68763     1-800-232-5762 or 1-402-336-4083        Information
Copyright Needak Manufacturing LLC 1999-2017.  No portion of this site may be used without permission.

All rights reserved.


Powered By AthenaGold